The GRN series utilizes ultra-low pressure drop stainless steel heat exchangers to process compressed air flows from 10 to 3000 SCFM. The refrigeration system is controlled by a highly reliable automatic or thermostatic expansion valve in lieu of non-adjusting capillary tube systems that can be responsible for premature refrigeration compressor failures.
The GNX series provides extremely energy efficient refrigerated drying capacity of 100 – 2,250 SCFM. The cycling Trans-Temp thermal mass system allows the unit to cycle on and off as changes in system load requires.
The EDR Series is designed to accept 23 to 129 SCFM of compressed air at temperatures up to 180°F. The integral ambient pre-cooler and water separator allows the compressed air to be dried to a 39°F Pressure Dewpoint which has a 33% lower moisture content than dryers with 50°F Pressure Dewpoint.
The GHRF series utilizes ultra-low pressure drop stainless steel heat exchangers to process compressed air flows from 75 to 3300 SCFM @ 600 PSIG. The refrigeration system is controlled by a highly reliable automatic or thermostatic expansion valve in lieu of non-adjusting capillary tube systems that can be responsible for premature refrigeration compressor failures.
The GMNF series is a modular design that utilizes ultra-low pressure drop stainless steel heat exchangers to process compressed air flows from 4,000 – 13,500 SCFM. As a company’s compressed air demand increases, modules can be added to facilitate a streamlined system expansion.
The GMNX series provides extremely energy efficient refrigerated drying capacity of 4,000 – 13,500 SCFM. The cycling Trans-Temp thermal mass allows each of the modular units to operate independently and cycle on and off as changes in system load requires
The GAC series utilizes ultra-low pressure drop stainless steel heat exchangers to process compressed air flows from 20 to 825 SCFM @ 100 PSIG to a 40°F discharge temperature.
The GPS Series is an industrial duty pressure swing adsorption (PSA) regenerative air dryer that delivers a reliable -40° pressure dewpoint with optional designs for -100°. The standard series is optimized for capacities of 25 to 3,000 SCFM
The GEH Series utilizes a low watt density Incoloy sheath heater to increase operational efficiency and reduce required purge air to 7% or less. The standard series is designed for capacities of 100 to 25,000 SCFM
GBS Blower Purge Regenerative Compressed Air Dryers
The GBS Series utilizes an atmospheric blower and low watt density Incoloy sheath heater to increase operational efficiency and eliminate required purge air in the Blower Only Mode. The standard series is designed for capacities of 100 to 25,000 SCFM. The standard Tri-Mode system allows an operator to select a mode of operation at any time.
The GMR Series is a pressure swing adsorption (PSA) regenerative air dryer with a full 10 minute NEMA cycle. It delivers a reliable -40° pressure dewpoint and features a compact and efficient design, which includes wall mount capabilities.
GHN Series air filters remove contaminates from compressed air after compression has taken place.
GW Series air filters remove contaminates from compressed air after compression has taken place.
Business Hours
Mon-Fri 8am-5pm
24-Hour Emergency